Slickform® is inexpensive, rapidly made to order concrete rustication forms manufactured from post industrial waste products.

Water does not readily pass through Slickform®, thereby patch and repair is greatly reduced. “Dusting” cannot occur.

Slickform® requires no special tools or adhesives. Simply attach Slickform® to the slab as you would any MDF, Particle board, or plywood. When the panel is raised, a glass-like reveal surface remains.

Peery Brothers Lumber has been supplying the lumber needs of concrete tilt-up construction since it first began replacing brick. Over the decades we have worked hard to meet our customers’ requests for readily available and less labor, less waste, lower cost, dependable, and consistent form material. The use of Slickform® solves all these problems with the added benefit of utilizing resources otherwise discarded one cycle earlier.

Because during the initial cure process the substrate does not come in contact with water, the substrate can be shaped out of just about any agricultural product. Due to an always ready supply, off-grade particle board or MDF are the preferred substrates. When particle board or MDF are first manufactured, defective and damaged sheets develop and are either thrown away or sold at deep discounts.

The laminate is either vinyl or coated paper. The laminates are initially produced with architectural prints used to simulate paneling and moldings. The prints soon become obsolete and the laminate is usually thrown away.

Slickform® recycles the substrate by utilizing its stability and natural workability while protecting it with the laminate, and recycles obsolete laminate prints never to be seen when used as forming. Textured laminates may also be used. Lightly textured laminate telegraphing is obscured with the first coat of paint, while deeply textured laminates may be specified for effect.

 © Copyright 2009 Peery Bros. Lumber Co. Inc.